Most engineers in the channel utilize a tool called the Dynamic Configuration Tool. This allows you to take a product, configure it with all of its software, hardware and licensing options, give it a sanity check and then output a spreadsheet. You then take spreadsheet and combine it with the other hardware in your design to create what is called a Bill of Materials (commonly referred to as a BOM). The challenge here is if you only use the Dynamic Configuration Tool, you will not see the storage specific options for the Nexus family of Data Center switches.

The solution is to use a tool called the Multi-line Configurator. In the video below, I will show you how to use this tool to create a working Nexus 5000 BOM for your customers. (for fullscreen hover your mouse over the video and click on the “X” next to the vimeo link.)

Normally I don’t discuss channel specific topics on this blog, but my fear is that other engineers in the channel may fumble when creating BOM’s around Nexus, and otherwise tarnish a really good product. Since channel specific topics is new to this blog, it would help me out if you could ping me if you found this useful. Depending on the response I receive I will start sprinkling in more of channel partner specific content in the future.
Similar Posts:

• Cisco Unified Computing System Quoting and Configuration with Netformx
• Me and the Nexus 7000 last week at the Data Center VT
• Link Round Up – L2TPv3 FCOE Trill Wounded Warriors
• Nexus 5020 – Consolidated 10 Gig Ethernet and 4 Gig Fibre Channel
• Cisco EMC and VMware partneship VCE VBlocks Acadia and the Partner Ecosystem
• Twitter Updates for 2008-06-05

--Colin McNamara

Cisco Nexus 5020 and 5010 FCOE video ordering guide